<Left margin correction>
Adjust the left margin for duplex printing from the cassette.
1) Duplex printing from the ASF and cassette
In the left margin correction mode, press the Resume/Cancel button 1 time, then press the Power button 1 time. Duplex printing is
performed from the ASF and cassette.
Number of times the
Resume/Cancel button is
From each paper source (ASF and cassette), 2 sheets of paper are ejected. The first sheet is blank, and the left margin correction pattern is
printed on the second sheet.
<Printing sequence>
For detail, see the flowcharts below.
i) A sheet of paper feeds from the ASF, and ejected blank (single-sided printing).
ii) A sheet of paper feeds from the ASF. Nothing is printed on the front side, and the pattern is printed on the back side
(duplex printing).
iii) A sheet of paper feeds from the cassette, and ejected blank (single-sided printing).
iv) A sheet of paper feeds from the cassette. The pattern is printed on both sides of paper (duplex printing).
A total of 4 sheets are ejected.
After this, set the correction value to the EEPROM in the steps below.
2) Selection of the parameter mode for left margin correction
Press the Resume/Cancel button the specified number of time(s) according to the parameter mode listed in the table below, then press the
Power button.
Each time the Resume/Cancel button is pressed, the Alarm and Power LEDs light alternately, Alarm in orange and Power in green.
Number of times the
Resume/Cancel button is
pressed (L)
0 times
No operation
1 time
Duplex printing from the ASF and cassette
Return to the service mode menu selection (no writing to the
2 times
EEPROM)
pressed (M)
0 times
Duplex printing from the ASF and cassette
1 time
Back side of paper fed from the ASF
2 times
Front side of paper fed from the cassette
3 times
Back side of paper fed from the cassette
Return to the service mode menu selection (after writing to the
4 times or more
EEPROM)
Operation
Parameter mode
1-25