Hardware Installation; Front Panel; Power Led; Stacking Ports (Se Models Only) - Kingston Technology KNE16SE User Manual

6

Hardware Installation

Before you begin installing network cables, please take a few moments to
familiarize yourself with the EtheRx hubs. The front and rear panels of the
Stackable hubs are used for illustration.
Note: WorkGroup hubs have identical features except for the Stacking Ports.

Front Panel

Utilization LEDs
STACK IN STACK OUT
UTIL %
COLL %
Stacking
Ports Collision LEDs
Fig. 1-1 KNE8TP/SE Front Panel
Utilization LEDs
STACK IN STACK OUT
UTIL % ACTIVITY / PARTITION
AUI BNC
COLL %
Collision LEDs
Stacking BNC Port LED
Ports
AUI Port LED
Fig. 1-2 KNE16TP/SE Front Panel

Power LED

The green LED indicates the power status. The LED will light when the AC
power transformer is connected from a power source to the hub.

Stacking Ports (SE models only)

The Stackable hub models (KNE8TP/SE and KNE16TP/SE) include a
"Stack-In" and "Stack-Out" port for stacking up to five (5) SE hubs in any
combination of 8-Port and 16-Port models. Refer to the section, "Stacking
EtheRx SE Hubs" on page 13 for additional information.
Kingston Technology Company
UTP Port LEDs
Stackable Hub
KNE8TP/SE
LINK / ACTIVITY / PARTITION
CASCADE
BNC 1 2 3 4 5 6 7 8
PWR
BNC Port LED Cascade
Power LED
Switch
UTP Port LEDs
LINK / ACTIVITY / PARTITION
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 CASCADE
Cascade
Switch
EtheRx User's Guide - Rev. B00
Hardware Installation
Stackable Hub
PWR KNE16TP/SE
Power LED