6
Automatic Partitioning / Reconnection
If any of the ports on the Fast EtheRx Hub experience excessive numbers of consecutive
collisions, duration collisions, or faulty conditions, that particular port can be partitioned.
Once partitioned, the hub will continue to monitor that port. If the error conditions have
been corrected or a good data packet is transmitted without incurring a collision, the hub
will automatically reconnect that port to the network.
Hardware Installation
Before you begin installing network cables, please take a few moments to familiarize
yourself with the front panel of your Fast EtheRx Hub. The functions on the front and
rear panels are illustrated below.
Front Panel
Fig. 1. Front Panel - 24-Port Model
Power LED
The green LED indicates the power status. The LED will light when the AC power cord
is connected from a power source to the hub and the power switch is turned on.
Collision LED
The amber LED displays the collision status. If a collision is detected on the network, the
amber LED will flash. For the Fast Ethernet CSMA/CD network, collisions can be quite
common. A collision occurs when two or more stations try to transmit data
simultaneously. Both stations will stop transmitting and then re-transmit after a random
period of time.
Fiber Module Detection LED
The Fiber Module Detection LED will light up if the optional 100FX module is installed.
This LED will not light up if the optional 100FX module is not installed.
Kingston Technology Company
Hardware Installation
II
KNE24TX/RS User's Guide - Rev. A01