Installation; Installation Requirements; Unpacking; Location - Blue Seal Evolution GP514 Installation And Operation Manual

Installation Requirements

NOTE:
• It is most important that this appliance is installed correctly and that operation is correct
before use. Installation shall comply with local gas, health and safety requirements.
• This appliance shall be installed with sufficient ventilation to prevent the occurrence of
unacceptable concentrations of health harmful substances in the room, the appliance is
installed in.
Blue Seal Gas Griddles are designed to provide years of satisfactory service and correct installation is
essential to achieve the best performance, efficiency and trouble-free operation.
This appliance must be installed in accordance with National installation codes and in addition, in
accordance with relevant National / Local codes covering gas and fire safety.
Australia:
New Zealand:
United Kingdom:
Ireland:
Installations must be carried out by qualified persons only. Failure to install equipment to the
relevant codes and manufacturer's specifications shown in this section will void the warranty.
Components having adjustments protected (e.g. paint sealed) by the manufacturer are only
to be adjusted by an authorised service agent. They are not to be adjusted by the installation
person.

Unpacking

• Remove all packaging and transit protection from the appliance including all protective plastic
coating from the exterior stainless steel panels.
• Check equipment and parts for damage.
distributor.
• Ensure that the 4 adjustable feet are fitted with the protruding centre screw.
• Report any deficiencies to the distributor who supplied the appliance.
• Check that the available gas supply is correct to that shown on the rating plate located behind the
front control panel and on the inner face of the right hand panel.

Location

1. Installation must allow for a sufficient flow of fresh air for the combustion air supply.
Natural Gas (G20)
LPG / Propane (G31)
2. Installation must include adequate ventilation means, to prevent dangerous build up of combustion
products.
3. Any gas burning appliance requires adequate clearance and ventilation for optimum and trouble-free
operation. The minimum installation clearances shown below are to be adhered to.
4. Position the appliance in its approximate working position.
5. All air for burner combustion is supplied from underneath the unit. The legs must always be fitted
and no obstructions placed on the underside or around the base of the unit, as obstructions will
cause incorrect operation and / or failure of the appliance.
6. Components having adjustments protected (e.g. paint sealed) by manufacturer are only allowed to
be adjusted by an authorised service agent. They are not to be adjusted by the installation person.
NOTE: Do not obstruct or block the appliances flue. Never directly connect a ventilation system to
the appliance flue outlet.
- AS5601
- NZS5261
- Gas Safety (Installation & Use) Regulations 1998.
- BS6173
- BS5440
- IS 820
Report any damage immediately to the carrier and
Combustion Air Requirements:
GP514
3
14 m /hr
3
15 m /hr
9
- Gas Installations.
- Gas Installation.
- Installation of Catering Appliances.
- 1 & 2 Installation Flueing & Ventilation.
- Non - Domestic Gas Installations.
GP516 GP518
3
21 m /hr 28 m
3
22 m /hr 29 m

Installation

3
/hr
3
/hr