Pioneer SPH-DA120 Operation Manual page 113

Appendix
Message
USB1 was disconnected for
device protection. Do not re-
insert this USB memory into
the unit.
USB2 was disconnected for
device protection. Do not re-
insert this USB memory into
the unit.
Audio Format not supported
iPod
Message
Error-02-6X/-9X/-DX
Error-02-67
iTunes tagging
Message
Error-8D
Tag store failed.
Already stored.
Memory full. Connect iPod.
Memory full. Tags not stored.
Connect iPod.
iPod full. Tags not transferred. Memory used for tag information on
Tag transfer failed. Reconnect
your iPod.
Bluetooth
Message
Error-10
Cause
The USB connector or USB cable is
short-circuited.
The connected USB storage device
consumes more than maximum al-
lowable current.
The USB interface cable for iPod /
iPhone is short-circuited.
This type of file is not supported on
this product.
Cause
iPod failure.
The iPod firmware version is old.
Cause
Built-in FLASH ROM encountered
an error.
Tag information cannot be stored in
this product.
This tag information is already
stored in memory.
The tag information is successfully
stored. The flash memory of this
product has become full.
This product's flash memory used
as the temporary storage area is
full.
the iPod is full.
This product's tag information can-
not transfer to the iPod.
Cause
The power failed for the Bluetooth
module of this product.
Action (Reference)
Check that the USB connector or USB cable
is not caught in something or damaged.
Disconnect the USB storage device and do
not use it. Turn the ignition switch to OFF,
then to ACC or ON and then connect a com-
pliant USB storage device.
Confirm that the USB interface cable for iPod
/ iPhone or USB cable is not caught in some-
thing or damaged.
Select a file that can be played. (Page 120)
Action
Disconnect the cable from the iPod. Once the
iPod's main menu is displayed, reconnect the
iPod and reset it.
Update the iPod version.
Action
Turn the ignition switch to OFF and then to
ON.
Try again.
Tag information can only be saved once for
any given song. Tag information cannot be
saved for the same song more than once.
The tag information on this product is trans-
ferred to the iPod automatically when an iPod
is connected.
The tag information on this product is trans-
ferred to the iPod automatically when an iPod
is connected.
Sync the iPod with iTunes and clean up the
tagged playlist.
Check the iPod and try again.
Action
Turn the ignition switch to OFF and then to
ON.
If the error message is still displayed after per-
forming the above action, please contact your
dealer or an authorised Pioneer Service Sta-
tion.
Appendix
113
Engb