• Electrical Starter Button
This is a starting motor button (switch) for engine starting.
With the main switch "ON", press this button while holding the front or rear brake lever will
start the engine.
CAUTION:
• Release this button immediately after engine has been started, and never press the button again
to avoid damaging the engine.
• This mechanism is a safety design. The engine can only be started after the front or rear brake
lever (pedal) has been applied.
• Do not use light system. Turn headlight and turn signal lights to the "OFF" position when the
engine is being started.
• High/Low Beam Switch
This is the high and low beam of headlight switching switch. Press this switch to switch between high
and low beams.
This is for high beam.
This is for low beam. (Please turn to low beam when riding in city)
• Passing Switch
Turn ignition switch "ON" and press this button down. Then, the high beam of headlight will
come on immediately to warn the driver of the vehicle ahead that you intend to overtake him/her.
(For overtaking, high beam indicator will come on at this time) This button will return to original
position after releasing
• Horn Switch
Press this button down when ignition switch is in the "ON" position, the horn will sound.
CAUTION:
Do not press this button when you are in the area where there's no honking.
Hazard Switch
The main switch in the 〝 ON 〞 position, cuts
according to this switch, four directions
lantern festivals dodge extinguish do move,
also can simultaneously dodge on the
display board direction indicating lamp
extinguishes does moves. If stops the
vehicle has when the transportation
frequent dangerous position or the vehicle
the breakdown, may use the dangerous
police to show the switch.
The main switch in the〝 ON 〞 position,
hazard switch only then may close.
7. Use of each component
10