Labels And Transparencies - Brother HL-3260N User Manual

CHAPTER 1 ABOUT THIS PRINTER

Labels and Transparencies

The printer will print on most type of labels and transparencies designed for
use with a laser printer. Labels should have an adhesive that is acrylic-
based since such material is more stable at the high temperatures in the
fusing unit. Adhesives should not come in contact with any part of the
printer, because the label stock may stick to the drum or rollers and cause
jams and print quality problems. No adhesive should be exposed between
the labels. Labels should be arranged so that they cover the entire page with
the only exposed spaces being lengthwise down the sheet. Using labels with
spaces may result in labels peeling off and causing serious jam or print
problems.
All labels and transparencies used in this printer must be able to withstand a
temperature of 200 degrees centigrade (392 degrees Fahrenheit) for a
period of 0.1 seconds.
Label and transparency sheets should not exceed the paper weight
specifications described in the User's Guide. Labels and transparencies
exceeding this specification may not feed or print properly and cause
damage to your printer.
Print quality, reliability and performance of labels and transparencies cannot
be guaranteed.
DAMAGE CAUSED BY THE USE OF UNSATISFACTORY LABELS OR
TRANSPARENCIES IS NOT COVERED UNDER ANY WARRANTY OR
SERVICE AGREEMENTS.
Downloaded from ManualsPrinter.com Manuals
1-31