Yardworks YW20PTP Instruction Manual page 14

Spark Plugs
Note: Not all spark plugs for engines are the same.
1. Use only the spark plugs that are recommended for this petrol pump: TORCH-L8RTC, Champion -CJ8Y,
NGK-BPM6A.
Note: Using a spark plug other than that specified could lead to serious engine damage.
2. Check the length of the thread, because if the thread is to long is will damage the engine beyond repair.
3. Make sure that the electrode is clean and the air gap is correct (refer to the specs of the spark plug
manufacture).
To remove, install and inspect the spark plug refer to the maintenance section of this instruction manual (page 16).
Starting the Engine
WARNING! Before starting please ensure all inspections stated above have been completed.
1. Turn the fuel lever (14) to the "Open" position (Fig. 10)
2. Lift the choke lever (15) to the "CLOSE" (start) position:
Note: No choke is required if the engine is warm. Make sure that the choke is in the
"OPEN" (run) position when starting a warm engine:
3. Turn the throttle lever (12) down towards the "L" position (Fig. 12).
4. Grip the recoil starter (16) and slowly pull until resistance is felt, then pull the
recoil starter rapidly. Allow the rope to rewind slowly and if necessary, repeat this
procedure until the engine fires briefly (Fig. 13).
OPERATION cont.
(Fig. 11)
14
Fig. 10
Fig. 11
Fig. 12
Fig. 13