Table of Contents
Advertisement
6. Align and screw the collar onto the thread of the suction inlet (8) port of the
pump (Fig. 5).
Note: Ensure the collar is tightly fastened onto the suction inlet (8); failure to do so
may result in an air leak.
Discharge Outlet
Connecting Hose or Pipe to the Discharge outlet (not included)
Note: Keep all hoses short and as straight as possible, failure to do so may decrease the pumps performance.
Caution: All connections must be air tight, failure to do so may result in an air leak which can prevent the pump
from priming. It is recommended that a thread sealant (not included) and/or Teflon tape (not included) is used on
threads to ensure a water tight seal and prevent any leakage.
1. Insert a hose adapter (24) into one of the collars (22).
Note: Ensure that an o-ring (21) is fitted into the collar (22) (Fig. 6), failure to do so
may result in an air leak.
2. Add thread sealant (not included) and/or Teflon tape (not included) on to the
discharge outlet (9).
3. Align and screw the collar onto the thread of the discharge outlet (9) port of the
pump (Fig. 7).
Note: Ensure the collar is tightly fastened onto the discharge outlet (9); failure to do so
may result in an air leak.
Priming
Priming the pump prepares the motor for safe operation.
Caution: Do not run the pump dry, this may result in damage to the pump.
1. Unscrew the priming cap (11) by turning anti-clockwise. Using a hose, fill the pump
by pouring water into the priming plug hole (Fig. 8).
2. Ensure that the pump and suction line are full.
3. Replace the priming cap (11) and ensure it is secure.
4. Fully open any shut off mechanisms (eg: spray nozzle, valves etc.) in the input and output hose or pipe so that
the air can escape without obstruction.
SETUP & INSTALLATION (cont.)
12
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Advertisement
Table of Contents
