Table of Contents
Advertisement
easyRAID Q16 Serial ATA Disk Array Systems
Upgrading Memory
The disk array system takes a single 200 pin PC200 DDR SDRAM SO-DIMM with a maximum
capacity of 1 GB. Follow these instructions to upgrade the memory.
1 Loosen the screws holding the controller cage in place.
2 Lift the handle and slide the controller-cage out of the chassis.
3 Carefully remove the cables from the daughter board, remove the three screws, and lift it
away from the array group controller.
Daughterboard
4 Pull the DIMM retaining clips away from the DIMM; the DIMM springs out of the
socket. Remove the DIMM.
Array group controller
28
Advertisement
Table of Contents
