Xerox Phaser 4500 Reference Manual page 164

Maintenance Safety
■
■
■
Operational Safety
Your printer and supplies were designed and tested to meet strict safety requirements. These
include safety agency examination, approval, and compliance with established environmental
standards.
Your attention to the following safety guidelines helps to ensure the continued, safe operation
of your printer.
Printer Location
Place the printer in a dust-free area within a temperature range of 41 degrees F to 95 degrees F
(5 degrees C to 35 degrees C) and a relative humidity range of 15 percent to 85 percent.
Printer Clearance
Place the printer in an area where there is adequate space for ventilation, operation, and
servicing. The recommended minimal spacing is:
Overhead Clearance:
■
■
Total Height Requirements:
■
■
Other Clearances:
■
■
■
■
■
Operational Guidelines
■
■
■
■
Downloaded From ManualsPrinter.com Manuals
Do not attempt any maintenance procedure that is not specifically described in the
documentation supplied with your printer.
Do not use aerosol cleaners. The use of supplies that are not approved may cause poor
performance and could create a hazardous condition.
Do not burn any consumables or routine maintenance items. For information on Xerox
supplies recycling programs, go to www.xerox.com/office/recycle.
40 cm (16 in.) above the printer without the 500-Sheet stacker
28 cm (11 in.) above the printer with the 500-Sheet stacker
Printer with Trays 1 and 2: 82 cm (32 in.)
Add an additional 9.6 cm (3.75 in.) for each optional 550-Sheet feeder
16 cm (6 in.) behind the printer
23 cm (9 in.) behind the printer when the duplex unit is installed
48 cm (19 in.) in front of the printer
21 cm (8 in.) on the left side of the printer
30 cm (12 in.) on the right side of the printer
Do not block or cover the slots and openings on the printer. The printer may overheat
without adequate ventilation.
For optimum performance, use the printer at elevations below 3,000 m (11,480 ft.).
Do not place the printer near a heat source.
Do not place the printer in direct sunlight.
Phaser™ 4500 Laser Printer
A-3