Adjusting The Bevel Angle; Stopper Arm; Adjusting The Miter Angle - Makita LS1018 Instruction Manual

WARNING:
After installing a new blade and with the tool
•
unplugged, always be sure that the blade does
not contact any part of the lower base when the
handle is lowered completely. If a blade makes
contact with the base it may cause kickback and
result in serious personal injury.

Stopper arm

1
2
010233
The lower limit position of the blade can be easily
adjusted with the stopper arm. To adjust it, move the
stopper arm in the direction of the arrow as shown in the
figure. Adjust the adjusting screw so that the blade stops
at the desired position when lowering the handle fully.

Adjusting the miter angle

2
1
010409
Loosen the grip by turning counterclockwise. Turn the
turn base while pressing down the lock lever. When you
have moved the grip to the position where the pointer
points to the desired angle on the miter scale, securely
tighten the grip clockwise.
CAUTION:
After changing the miter angle, always secure the
•
turn base by tightening the grip firmly.
NOTICE:
When turning the turn base, be sure to raise the
•
handle fully.
1. Stopper arm
2. Adjusting screw
1. Miter scale
2. Pointer
3. Lock lever
4. Grip
3
4

Adjusting the bevel angle

1
011337
To adjust the bevel angle, loosen the lever at the rear of
the tool counterclockwise. Unlock the arm by pushing the
handle somewhat strongly in the direction that you intend
to tilt the saw blade.
NOTE:
Lever can be adjusted to a different lever angle by
•
removing the screw holding the lever and securing
the lever at a desired angle.
1
2
3
011336
Tilt the saw blade until the pointer points to the desired
angle on the bevel scale. Then tighten the lever
clockwise firmly to secure the arm.
1
011337
When tilting the carriage to the right, tilt the carriage to
the left slightly after loosening the lever and press the
releasing button. With the releasing button being pressed,
tilt the carriage to the right.
8
1. Lever
1. Lever
4
2. Arm
3. Pointer
4. Bevel scale
1. Lever