Slide Lock Adjustment; Switch Action - Makita LS1018 Instruction Manual

1
2
3
011353
Tilt the saw blade until the pointer points to the desired
angle on the bevel scale. Then tighten the lever
clockwise firmly to secure the arm.
When changing bevel angles, be sure to position
•
the kerf boards appropriately as explained in the
"Positioning kerf boards" section.
CAUTION:
After changing the bevel angle, always secure the
•
arm by tightening the lever clockwise.
NOTICE:
When tilting the saw blade be sure the handle is
•
fully raised.
When changing bevel angles, be sure to position
•
the kerf boards appropriately as explained in the
"Positioning kerf boards" section.

Slide lock adjustment

010431
To lock the slide pole, turn the locking screw clockwise.

Switch action

For European countries
1
3
010238
To prevent the switch trigger from being accidentally
pulled, a lock-off button is provided. To start the tool, push
the lever to the left, press in the lock-off button and then
pull the switch trigger. Release the switch trigger to stop.
1. Pointer
2. Release button
3. Bevel scale
1. Locking screw
1
1. Lock-off button
2
2. Switch trigger
3. Lever
4. Hole for padlock
4
WARNING:
Before plugging in the tool, always check to see that
•
the switch trigger actuates properly and returns to
the "OFF" position when released. Do not pull the
switch trigger hard without pressing in the lock-off
button. This can cause switch breakage. Operating a
tool with a switch that does not actuate properly can lead
to loss of control and serious personal injury.
A hole is provided in the switch trigger for insertion of
padlock to lock the tool off.
For all countries other than European countries
1
010237
To prevent the switch trigger from being accidentally
pulled, a lock-off button is provided. To start the tool,
press in the lock-off button and pull the switch trigger.
Release the switch trigger to stop.
WARNING:
Before plugging in the tool, always check to see that
•
the switch trigger actuates properly and returns to
the "OFF" position when released. Do not pull the
switch trigger hard without pressing in the lock-off
button. This can cause switch breakage. Operating a
tool with a switch that does not actuate properly can lead
to loss of control and serious personal injury.
A hole is provided in the switch trigger for insertion of
padlock to lock the tool off.
WARNING:
Do not use a lock with a shank or cable any
•
smaller than 6.35 mm in diameter. A smaller
shank or cable may not properly lock the tool in the
off position and unintentional operation may occur
resulting in serious personal injury.
NEVER use tool without a fully operative switch
•
trigger. Any tool with an inoperative switch is HIGHLY
DANGEROUS and must be repaired before further
usage or serious personal injury may occur.
For your safety, this tool is equipped with a lock-off button
•
which prevents the tool from unintended starting. NEVER
use the tool if it runs when you simply pull the switch
trigger without pressing the lock-off button. A switch in
need of repair may result in unintentional operation and
serious personal injury. Return tool to a Makita service
center for proper repairs BEFORE further usage.
9
1. Lock-off button
2
2. Switch trigger
3. Hole for padlock
3