Makita LS1018 Instruction Manual page 18

1
2
010469
When securing aluminum extrusions, use spacer
blocks or pieces of scrap as shown in the figure to
prevent deformation of the aluminum. Use a
cutting lubricant when cutting the aluminum
extrusion to prevent build-up of the aluminum
material on the blade.
WARNING:
Never attempt to cut thick or round aluminum
•
extrusions. Thick or round aluminum extrusions
can be difficult to secure and may work loose
during the cutting operation which may result in
loss of control and serious personal injury.
8. Wood facing
Use of wood facing helps to assure splinter-free
cuts in workpieces. Attach a wood facing to the
guide fence using the holes in the guide fence.
See the figure concerning the dimensions for a
suggested wood facing.
15mm Over 500 mm
24 mm
68mm 121mm
1
1. Holes
010563
CAUTION:
Use straight wood of even thickness as the wood
•
facing.
WARNING:
Use screws to attach the wood facing to the
•
guide fence. The screws should be installed
so that the screw heads are below the surface
of the wood facing so that they will not interfere
with the positioning of the material being cut.
Misalignment of the material being cut can case
unexpected movement
operation which may result in a loss of control and
serious personal injury.
1. Aluminum
3
extrusion
2. Guide fence
3. Spacer block
4. Horizontal vise
(optional
accessory)
4
80mm-90mm
20 mm
1
68mm
121mm
during the
NOTICE:
When the wood facing is attached, do not turn the
•
turn base with the handle lowered. The blade
and/or the wood facing will be damaged.
9. Groove cutting
001563
A dado type cut can be made by proceeding as
follows:
Adjust the lower limit position of the blade using the
adjusting screw and the stopper arm to limit the
cutting depth of the blade. Refer to "Stopper arm"
section described previously.
After adjusting the lower limit position of the blade,
cut parallel grooves across the width of the
workpiece using a slide (push) cut as shown in the
figure. Then remove the workpiece material
between the grooves with a chisel.
WARNING:
Do not attempt to perform this type of cut by
•
using a wider type blade or dado blade.
Attempting to make a groove cut with a wider blade
or dado blade could lead to unexpected cutting
results and kickback which may result in serious
personal injury.
Be sure to return the stopper arm to the original
•
position when performing other than groove
cutting. Attempting to make cuts with the stopper
arm in the incorrect position could lead to
unexpected cutting results and kickback which may
result in serious personal injury.
CAUTION:
Be sure to return the stopper arm to the original
•
position when performing other than groove
cutting.
cutting
18
1
1. Cut grooves with
blade