Makita LS1018 Instruction Manual page 10

NEVER defeat the lock-off button by taping down or
•
some other means. A switch with a defeated
lock-off button may result in unintentional operation
and serious personal injury.
Electronic function
Soft start feature
This function allows the smooth start-up of the tool
•
by limiting the start-up torque.
Laser beam action
For model LS1018L only
NOTE:
Before the first use, install two AA dry cells in the
•
cell box. Refer to the section titled "Replacing the
dry cells for laser unit" for the installment.
CAUTION:
When not in use, be sure to turn off the laser
•
1
010257
CAUTION:
Never look into the laser beam. Direct laser beam
•
may injure your eyes.
LASER RADIATION, DO NOT STARE INTO THE
•
BEAM, CLASS 2 LASER PRODUCT.
Before shifting the laser line or performing maintenance
•
adjustment, be sure to unplug the tool.
To turn on the laser beam, press the upper position (I) of
the switch. To turn off the laser beam, press the lower
position (0) of the switch.
Laser line can be shifted to either the left or right side of
the saw blade by loosening the screw holding the laser
unit box and shifting it in the desired direction. After
shifting, be sure to tighten the screw.
1. Switch for laser
10
1. Screw holding the laser unit box
010473
Laser line is factory adjusted so that it is positioned within
1 mm from the side surface of the blade (cutting position).
NOTE:
When laser line appears dim and hard to see
•
because of direct sunlight, relocate the work area to
a place where there is less direct sunlight.
Replacing the dry cells for laser unit
010399
1
010259
Remove the lid for the dry cells for laser unit by sliding
while pressing it. Take out the old dry cells and put the
new ones as shown in the figure. After replacing, return
the lid to cover it.
Cleaning of the lens for the laser light
If the lens for the laser light becomes dirty, or sawdust
adheres to it in such a way that the laser line is no longer
easily visible, unplug the saw and remove and clean the lens
for the laser light carefully with a damp, soft cloth. Do not use
solvents or any petroleum-based cleaners on the lens.
1
1. Dry cell