Intelix DIGI-HD-1X8 Installation Manual

DIGI-HD-1X8 Installation Manual
The Intelix DIGI-HD-1X8 seamlessly distributes on hdmi input to
seven twisted pair and one HDMI outputs using built-in twisted
pair extenders to provide HD video at distances up to 300 feet
when used with compatible Intelix twisted pair receivers, such as
the DIGI-HD-UHR2-R, DIGI-HD-IR2-R, and DIGI-HD-XR.
When distributing HDMI audio and video over twisted pair
cabling, the DIGI-HD-1X8 requires a single Cat 5e or Cat 6 cable.
When distributing HDMI audio and video and IR over twisted pair
cabling, the DIGI-HD-1X8 requires two Cat 5e or Cat 6 cables. IR is
transmitted from the display location, through the compatible
Intelix twisted pair receiver, over the twisted pair cable, and out
of the IR OUT port on the DIGI-HD-1X8
The DIGI-HD-1X8 has an HDMI output, allowing up to five DIGI-
HD-1X8s to be linked together for a total of 36 outputs.
The DIGI-HD-1X8 supports 3D, is HDCP compliant, and features
proprietary Intelix HDshāk processing, including bandwidth
limiting and custom EDID configuration and emulation.
Compatible Devices
Compatible Receivers: DIGI-HD-UHR2-R, DIGI-HD-UHR2-WP-
R, DIGI-HD-IR2-R, DIGI-HD-IR3-WP-R, DIGI-HD-XR
Maximum Recommended Distances
1080p 1080i
Shielded 150' 300'
Cat 6a
Cat 6 110' 220'
Cat 5e 100' 200'
to the source equipment.
720p 576i/p 480i/p
300' 300' 300'
220' 220' 220'
200' 200' 200'
8001 Terrace Ave
Suite #201
Middleton, WI 53562
Important notice:
Do not attempt to disassemble or alter the extender
housing. There are no user-serviceable parts inside the
unit. Doing so will void your warranty.
To minimize the possibility of equipment damage from
electrostatic discharge
destination equipment must be powered off during
installation.
Do not connect the extender to a telecommunication
outlet wired to unrelated equipment. Doing so may
damage the unit or any connected equipment. Ensure
all connected twisted pair cabling is straight-through
(point-to-point).
Allow proper ventilation to reduce the risk of thermal
failure.
Twisted Pair
Wiring - Use
T568B wiring
for Cat5e/6
connection
between send
and receive
units.
Instructions
1. Turn off power and disconnect the audio/video
equipment by following the manufacturer's
instructions.
2. Adjust DIP switches for desired mode.
3. Connect all twisted pair cables (ensure T568B
straight-thru wiring).
4. Connect HDMI cable between source and DIGI-
HD-1X8 input.
5. Connect power supplies.
6. Power on attached audio/video devices.

Front Panel Indicators

When the unit is in a Dual UTP Mode, LEDs on the
front panel indicate connection with an attached
receiver. When the unit is in Single UTP Mode, LEDs
on the front panel will all be lit (except output 1) to
indicate that video is being sent out all outputs. In
either mode, the output 1 indicator will only be lit
when sending video to a compatible sink device.
(ESD), all source and
Phone: 608-831-0880
Toll-Free: 866-4-MATMIX
Fax: 608-831-1833