Direct/Limit Search - Radio Shack Realistic PRO-2030 Manual

LIMIT SEARCH
Limit Search lets you search within a range of frequencies. -L- appears on the display during a limit
search.
1. Press PGM, then LIMIT. Lo appears on the display.
2. Enter the lower limit of the frequency range you want to search.
3. Press ENTER, then LIMIT. Hi appears on the display.
4. Enter the upper limit of the frequency range you want to search.
5. Press ENTER.
6. Press /\ to search up from the lower limit. Or press \/ to search down from the upper limit.
7. When the scanner stops on a transmission, press MON to store the frequency in the current
monitor memory, or press /\ or \/ to continue the search.
Note: As you store frequencies in monitor memories, the flashing numbers to the right of MON
indicates the current monitor memory. The new frequency will replace the previously stored
frequency.
DIRECT SEARCH
When you are in program or manual mode, you can search up or down from the current displayed
frequency. -d- appears on the display during a direct search.
1. Press MAN and the channel number to select a channel into which you have programmed a
frequency. Then press MAN or PGM to enter the channel number from which yo u want to
start your search.
2. Press /\ or \/ to search up or down from the display frequency.
3. When the scanner stops on a transmission, press MON to store the frequency in the current
monitor memory, or press /\ or \/ to continue the search.
NOTE: Press DLY to make the scanner pause 2 seconds after a transmission before it proceeds
to the next frequency.