Connecting An External Speaker; Resetting And Initializing The Scanner - Radio Shack Realistic PRO-2030 Manual

Note: This scanner uses a BNC antenna connector. You may need an antenna adapter, such as Cat.
No. 278-120 to use other antennas.
WARNING: When installing or removing an outdoor antenna, use extreme caution. If the antenna
starts to fall, let it go! It could contact overhead power lines. IF THE ANTENNA TOUCHES THE
POWER LINE, CONTACT WITH THE ANTENNA, MAST, CABLE, OR GUY WIRES CAN
CAUSE ELECTROCUTION AND DEATH! Call the power company to remove the antenna. Do not
attempt to do so yourself.

CONNECTING AN EXTERNAL SPEAKER

In a noisy area, an extension speaker, such as RadioShack Cat. No. 21-549, positioned in the right
place, might provide more comfortable listening.
Plug the speaker cable's 1/8- inch (3.5 mm) mini plug into the EXT SP jack on the back of the scanner.
This automatically disconnect the internal speaker.

RESETTING AND INITIALIZING THE SCANNER

If the scanner's display locks up or does not work properly after you connect the power source, you
might have to reset the scanner's display or initialize the scanner.
Follow these steps to reset the display.
1. Press POWER to turn on the scanner.
2. Press RESET on the back of the scanner using a pointed object, such as a ball-point pen.
3. Press POWER to turn on the scanner.
If this is not effective, initialize the scanner as directed below.
CAUTION: Initialize the scanner only when you are sure it is not working properly. This procedure
clears all information you have programmed into the scanner.
1. Press POWER to turn on the scanner.
2. Press and hold CLEAR and then press RESET on the back of the scanner using a pointed
object, such as a ball-point pen.
3. Press POWER to turn on the scanner.