NEC NP03LM Important Information Manual page 9

The connection of a unshielded equipment interface cable to this equipment will
invalidate the FCC Certifi cation of this device and may cause interference levels
which Exceed the limits established by FCC for equipment.
You are cautioned that changes or modifications not expressly approved by
the party responsible for compliance could void your authority to operate the
equipment.
Regulatory Information/Disclaimers
Installation and use of this Wireless LAN device must be in strict accordance with
the instructions included in the user documentation provided with the product. Any
changes or modifi cations (including the antennas) made to this device that are not
expressly approved by the manufacturer may void the user ' s authority to operate
the equipment. The manufacturer is not responsible for any radio or television
interference caused by unauthorized modifi cation of this device, or the substitution
of the connecting cables and equipment other than manufacturer specifi ed. It is the
responsibility of the user to correct any interference caused by such unauthorized
modifi cation, substitution or attachment. Manufacturer and its authorized resellers
or distributors will assume no liability for any damage or violation of government
regulations arising from failing to comply with these guidelines.
IEEE 802.11b or 802.11g operation of this product in the U.S.A. is fi rmware-limited
to channels 1 through 11.
CAUTION
This equipment complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This device and its antenna must not be co-located or
operating in conjunction with any other antenna or transmitter.
To comply with FCC RF exposure compliance requirements, the antenna used
for this transmitter must be installed to provide a separation distance of at
least 7.87"/20cm from all persons and must not be co-located or operating in
conjunction with any other antenna or transmitter.
This Class B digital apparatus complies with Canadian RSS-210.
Cet appareil numerique de la Classe B est conforme a la norme CNR-210 du
Canada.
Industry Canada Statement
This device complies with RSS-210 of the Industry Canada Rules. Operation is
subject to the following two conditions:
1) this device may not cause interference and
2) this device must accept any interference, including interference that may cause
undesired operation of the device
Regulatory Statement:
Operation of this device is subjected to the following National regulations and may
be prohibited to use if certain restriction should be applied.
- 9 -