Installation Instructions - GE PROGRAMMABLE THERMOSTAT Installation Instructions Manual

Installation Instructions

1. Always turn off power to the air conditioning or heating system
prior to installing thermostat.
2. Determine the HVAC equipment type. Compatible equipment
is:
a. 1 Stage Heat / 1 Stage Cool Conventional System
b. 2 Stage Heat / 2 Stage Cool Conventional System
c. 3 Stage Heat / 2 Stage Cool Conventional System
d. 1 Stage Heat / 1 Stage Cool Heat Pump System
e. 2 Stage Heat / 2 Stage Cool Heat Pump System
f. 3 Stage Heat / 2 Stage Cool Heat Pump System
3. Refer to the wiring diagrams to determine the number of
wires necessary to install this thermostat.
4. Ensure the power to the air conditioning or heating system is
turned off.
5. Remove front of thermostat body from sub-base.
6. Guide thermostat wires through center hole in sub-base.
7. Place the thermostat sub-base against wall in the desired
thermostat location.
8. Mark placement of mounting holes as appropriate.
9. Remove thermostat sub-base from wall and install wall
anchors as required at mounting hole locations.
10. Re-insert wires through center hole of sub-base and replace
sub-base on wall.
3