Installation
Instructions
If you have questions, call 800-GECARES or visit our Website at: www.GEAppliances.com
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT –
•
instructions for local inspector's use.
IMPORTANT –
•
governing codes and ordinances.
Note to Installer –
•
instructions with the Consumer.
Note to Consumer –
•
for future reference.
• Skill level – Installation of this appliance requires
basic mechanical skills.
• Completion time – 1 hour
• Proper installation is the responsibility of the
installer.
• Product failure due to improper installation is not
covered under the Warranty.
THERMOSTAT LOCATION
• On an interior wall, since the temperature of an
exterior wall varies with outdoor conditions,
approximately 5 ft (1.5 m) above the floor.
• No less than 18 inches from the junction of an outside
wall and away from direct sunlight, radiant heat, air
discharge grilles, stairwells, outside doors or behind
doors.
• Away from steam pipes, water pipes or warm-air stacks
in adjacent rooms.
Save these
Observe all
Be sure to leave these
Keep these instructions
5 ft (1.5 m)
18 in.
Get other manuals https://www.bkmanuals.com
Thermostats
RAK147P1
TOOLS REQUIRED
Pencil
Drill
Anchors and screws
MOUNTING AND WIRING
CAUTION:
Disconnect the electrical power
supply before wiring connections are made to prevent
damage to the thermostat.
1
REMOVE BASE FROM
THERMOSTAT
Open the cover on the thermostat and insert a small
coin or flat-bladed screwdriver in the slot on the top of
the thermostat and twist 1/4 turn. Grasp the base from
the side and remove from the thermostat.
RAK163P1
Screwdriver
Hammer
Caulking material
or putty
11