Adjusting The Handle - Edwards & Co Ed & Co FA005 Instruction Manual

Adjusting the handle

To adjust the handle, squeeze and hold both handle release buttons
located near the circular shaped hinge, rotate the handle then
release the button. The handle will lock into a position when you
CLICK!
hear a
There are three positions (as pictured):
1. Handle up – for carrying your child or when fitted into your car
or stroller.
IMPORTANT
– the handle must be in this position when fitted
to your car as it provides additional protection in the event of a
collision.
2. Handle lock – when locking the capsule into your stroller.
3. Handle down – it can be used for rocking your baby on a firm,
safe, flat surface.
designed & printed in NZ
Installing the seat to your car
1. Place the car seat into a forward-facing passenger seat and
face the car seat towards the rear of the vehicle.
IMPORTANT
pictured in Figure 1.
2. Pull the lap belt as pictured in Figure 1. (A) over the foot area of
the car seat and through the two lap belt guides as pictured in
Figure 1. (B).
6
designed & printed in NZ
- Check the handle is in the 'Handle up' position as
(continued next page)
7