Remove The Backplate And Cable Clamp - Light Wave JSJSLW920 Instruction Manual

Installation

Remove the backplate and cable clamp

Hook
To gain access to the wiring terminals on
the Boiler Switch, you must first remove
the backplate. This can be done by
loosening the two screws sited at the
base of the unit using a suitable
screwdriver. Once the screws are
loosened enough so that they protrude
from their screw holes, gently lift the
backplate away from the main unit and
slide it down. Once the hooks are free
from their mountings, the backplate
should slide free.
Screws
Once the backplate has been removed, the
cable clamp needs to be unscrewed ready
to accommodate the wires. There are also
two capped holes situated at the base of
the unit. One of these (or two depending
on the number of cables used) needs to
have its cap removed using a suitable
Holes
Clamp
blade so that the wires can pass through.