Device Setup; Linking The Boiler Switch To The Home Thermostat - Light Wave JSJSLW920 Instruction Manual

Device Setup

Linking the Boiler Switch to the Home Thermostat

In order to schedule your heating and to use the heating
remotely, you will need to 'link' the Boiler Switch to the
LightwaveRF Home Thermostat. The Boiler Switch can
be linked to the Thermostat using the following method.
1.
Press and release the 'Link' button on the Boiler Switch
(the on and o LEDs will flash alternately).
2.
Press and release the 'Link' button on the Home
Thermostat. 'Link Ok' should appear on the display to
indicate a successful link.
To unlink a Home Thermostat, press and release the
Linking button on the Boiler Switch and then press the
Standby button. This activates 'unlinking' mode. Press the
Link button on the Thermostat. The 'deleted' should flash
on the screen indicate that the devices have been unlinked.
To completely clear the memory of the Boiler Switch, press
and release the Linking button. Then hold the Linking
button until the LEDs flash rapidly. Finally, press and release
the Linking button once more. The O LED should flash.