Table of Contents
Advertisement
Available languages
Available languages
These types of heater can be recognised by a single switch on the side of the housing
and the blue standby LED:
AUS/OFF
AN/ON
The units come supplied with an infrared remote control which allows you to switch
between three power levels (50%, 80% and 100% power):
To set your HEATSCOPE® radiant heater to different power levels using the IR remote
control, proceed as follows:
Standby – the radiant heater is ready for use.
Press the AN/AUS – ON/OFF button.
The radiant heater is set to level 3 (100% power).
Press the DOWN or UP button to decrease or increase the power.
The radiant heater is set to level 2 (80% power).
Press the DOWN or UP button to decrease or increase the power.
The radiant heater is now set to level 1 (50% power).
· ···
By pushing the MIN./MAX. button, the radiant heater will jump in the
maximum (100%) resp. in the minimum (50%) power level.
By pushing the AN/AUS – ON/OFF button again,
the radiant heater will return to standby mode.
O
I
AN/AUS
ON/OFF
UP
+ 1 level
DOWN
- 1 level
· ···
MIN.
MAX.
EN
AMBIENT HEATING
Advertisement
Table of Contents
