Heatscope Spot Original Installation And Instruction Manual page 21

6. Operation, installation instructions and minimum distances
Once you have installed the unit, you can use it for the first time.
The HEATSCOPE® features an omnipolar „ON/OFF" switch. You can control the radiant heater manually using a
selector switch on the unit itself or using an IR remote control which comes supplied (depending on the model).
The unit must be connected to a residual current circuit breaker and a fuse.
It is recommended that you only install the unit in indoor or outdoor areas that are well protected from any
weather influences from above like rain and dust. The heater is protected from lateral spray water, but is has
to be covered with a roof or a similar canopy upwards.
The radiant heater must be installed at a height of at least 180 cm and at a distance of at least 40 cm from each
adjacent wall. The distance between the radiant heater and the rear surface must be at least 10 cm (this dis-
tance can be achieved using the supplied fixing accessories). Other protective measures may need to be taken
in accordance with local fire safety regulations, e.g. for installation on cumbustible surfaces.
The radiant heater must not be installed directly below a power socket. The sides of the HEATSCOPE® must be
at least 10 cm from any power sockets.
All cables must be positioned so that they cannot come into contact with the radiant heater at any time.
The dimensions given are minimum valuesand may deviate from the local building and fire safety regulations.
The latter must be complied with at all times.
The fixing surfaces shown must comply at least with fire protection class A2. The HEATSCOPE® complies with IP
44 protection class requirements (dust and splash-proof).
Required minimum distances from combustible fixing surfaces:
B
A
B
D
A
C
A
E
C
A min. 40 cm
B min. 50 cm
F
C min. 180 cm
D min. 17 cm
(can be achieved using the supplied
fixing accessories)
E min. 20 cm (with heating angle < 45°)
F min. 10 cm
(can be achieved using the supplied
fixing accessories)
EN