Heatscope Spot Original Installation And Instruction Manual page 19

EN
rated with a separate automatic thermostat or timer. When a radiant heater is installed in a bathroom, the CE
standard requires that at least one heating element visibly „glows" as soon as the unit is switched on.
8.
As soon as the unit is connected to a power source and switched on using an „ON/OFF" switch or other ope-
rating component, it takes a maximum of 10 seconds until it reached its operating temperature.
9.
CAUTION: Risk of burns!
The front screen or protective fin front gets very hot when the unit is operating.
Do not cover either part of the front or the entire front of the radiant heater. Do not touch any part of the
HEATSCOPE® during operation and up to 60 minutes after switching it off.
10.
For your own safety, never dry textiles or other materials using the HEATSCOPE®. Covering the radiant heater
may result in a fire!
11.
Ensure that cables, furniture, flammable materials or other objects do not come into contact with the surface
of the radiant heater and never cover the unit. Under no circumstances should the unit be covered with
insulating or similar materials.
12.
Disconnect the radiant heater from the power supply before cleaning it, adjusting the angle or removing it
from the wall/ceiling. If buried cables are used, switch off the power using an omnipolar switch.
13.
Be careful when operating the unit. This unit is not intended for use by persons (including children) with
reduced physical, sensory or mental abilities or lack of experience and/or knowledge, unless they are super-
vised by a person responsible for their safety or have received instructions as to how to operate/use the unit.
14.
The unit must never be used unattended. Children must be supervised at all times to ensure that they do not
play with the unit, switch it on unintentionally or adjust it.
15.
Use only the supplied accessories or original accessories approved by the manufacturer. The power cable
or other components of the HEATSCOPE® radiant heater may only be replaced by a professional servicing
company enlisted by the manufacturer.
16.
Always remember to switch off the unit after use.