Fan/Heat Sink Assembly - HP ENVY 17 Maintenance And Service Manual

Fan/heat sink assembly

NOTE: The fan/heat sink assembly spare part kit includes replacement thermal material. Replacement
thermal material is also available in the Thermal Material Kit, spare part number 634366-001.
Description
For use only on computer models with USB 3.0 capability
For use only on computer models with USB 2.0 capability
NOTE: To properly ventilate the computer, allow at least 7.6 cm (3 in) of clearance on the left side of
the computer. The computer uses an electric fan for ventilation. The fan is controlled by a temperature
sensor and is designed to turn on automatically when high temperature conditions exist. These
conditions are affected by high external temperatures, system power consumption, power
management/battery conservation configurations, battery fast charging, and software requirements.
Exhaust air is displaced through the ventilation grill located on the left side of the computer.
Before removing the fan/heat sink assembly, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
a. Subwoofer (see
b. Hard drive (see
c. Top cover (see
d. System board (see
Remove the fan/heat sink assembly:
1. Turn the system board upside down, with the front toward you.
2. Disconnect the two fan cables (1) from the system board.
3. Remove the three Phillips PM2.5×4.5 screws (2) that secure the fan/heat sink assembly to the
system board.
4. Following the 1 through 7 sequence stamped into the fan/heat sink assembly, loosen the seven
captive screws (3) that secure the fan/heat sink assembly to the system board.
5. Remove the fan/heat sink assembly (4).
74 Chapter 4 Removal and replacement procedures
Battery on page 39), and then remove the following components:
Subwoofer on page 41)
Hard drive on page 51)
Top cover on page 56)
System board on page 70)
Spare part number
689993-001
665908-001
ENWW