Power Connector Cable - HP ENVY 17 Maintenance And Service Manual

Power connector cable

Description
Power connector cable
Before removing the power connector cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
a. Subwoofer (see
b. Hard drive (see
c. Top cover (see
d. System board (see
Remove the power connector cable:
1. Turn the system board upside down, with the rear edge toward you.
2. Disconnect the power connector cable from the system board.
Reverse this procedure to install the power connector cable and bracket.
ENWW
Battery on page 39), and then remove the following components:
Subwoofer on page 41)
Hard drive on page 51)
Top cover on page 56)
System board on page 70)
Component replacement procedures
Spare part number
665907-001
73