Table of Contents
Advertisement
Installation
3.9. Connecting of the water
hose to the cold water mains line
ASP341 models only
(This feature is optional)
If you will use the refrigerator by connecting it
to the cold water mains line, you must install a
standard 1/2" valve connector to the cold water
installation of your home. If this valve is not present
or you are not sure, consult a qualified plumber.
1. Separate the union from the tap adaptor.
2. Install the tap adaptor to standard 1/2" valve
connector.
3. After inserting the water hose to the union, install
it to the tap adaptor and insert to the union to the
tap adapter.
4. Tighten the union by hand.
A
WARNING:
to suitable points by means of the
clips supplied to avoid any damage or
displacement or accidental disconnection.
A
WARNING:
valve, make sure that there is no leakage
at both connection points of the water
hose. If there is a leakage, turn off the
valve immediately and tighten all joints
again using a spanner or a pliers.
A
WARNING:
valve connector is available and completely
turned off on your cold water mains line.
3.10. Water filter
(This feature is optional)
Your refrigerator may be equipped with an external
or internal filter depending on its model. To fit the
water filter, follow the instructions below referring
to the figures supplied:
Secure the water hose
After turning on the water
Make sure that standard 1/2"
10 / 30 EN
Refrigerator / User Manual
Advertisement
Table of Contents
