Connection Of Water Hose To The Jug; Connection Of The Water Pipe To The Cold Water Mains Line - Beko GNE V322 PX Manual

Connection of Water Hose to
the Jug
(in some models)
To connect water to the refrigerator
from a jug, a pump is needed. Follow
the instructions below after connecting
one end of the water pipe coming
out of the pump to the refrigerator as
described on the previous page.
1. Finish the connection by pushing
the other end of the water pipe into
the water pipe inlet of the pump as
shown in the figure.
2. Put and fix the pump hose into the
jug as shown in the figure.
3. After completing the connection, plug
in and run the pump.
To provide an efficient operation of the
pump, wait for 2-3 minutes after
starting the pump.
C
Note: You may refer to the user
manual of the pump while making the
water connection.
Connection of the Water
Pipe to the Cold Water Mains
Line
(in some models)
If you want to use your refrigerator
by connecting it to the cold water
mains line, you will have to connect a
standard 1/2" valve connection fitting
to the cold water supply in your house.
In case this valve is not present or
in case you are not sure, consult a
qualified plumber.
1a
1b
2
17
EN