Adding Oil; Adding Fuel - Ford FG6250E Operator's Manual

Antidotes for battery acid
CONTACT TREATMENT
External Flush with water.
Internal Drink large quantities of milk or water, followed by milk of
magnesia, vegetable oil or beaten eggs. Get immediate
madical attention.
Eyes Flush with water. Get immediate madical attention.
Adding / Checking Engine Oil (See fig 5)
• Place generator on a level surface.
• Remove the crankcase dipstick to ensure you do not overfill the engine.
• Insert a funnel into the crankcase dipstick hold and carefully add 4-Cycle engine oil (SAE10W- 30) to empty reservoir
until oil reaches the outer edge of the oil fill hole (crankcase dipstick hole).
• Be sure to replace dipstick before attempting to start the engine.
• To check oil, set generator on a level surface, wipe dipstick clean, then reinsert dipstick without rethreading.
Adding Fuel (See fig 6)
• Set generator on a clean and level surface in an area that is well ventilated.
• Remove fuel cap.
• Insert a funnel into the fuel tank and carefully pour gasoline into the tank until fuel level reaches 1 ½ inches below the
top of the neck. Be careful not to overfill the tank to provide space for fuel expansion.
You must add oil before first operating this generator. Always check oil level before each
CAUTION!
operation.
DO NOT USE E15 OR E85 FUEL IN THIS UNIT. IT IS A VIOLATION OF FEDERAL LAW AND
WILL DAMAGE THE UNIT AND VOID YOUR WARRANTY.
Fig 5
ASSEMBLY
12
Fig 6