Attaching Wheels - Ford FG6250E Operator's Manual

Remove Shipping Bracket (See fig 1)
• Remove and discard the RED shipping bracket and mounting hardware before starting the Generator.
Attaching Wheels (See fig 2)
• Parts needed - 2 wheels, 2 axles, 2 hair pins, 4 washers, 2 hub caps and 2 self-tapping screws.
• Raise or tilt generator so you can slide the wheel axle pin into the wheel, the washer, the wheel mounting hole located
on the side of the frame and the other washer.
• Secure the wheel assembly by reinserting a hair pin through hole at the end of the wheel axle and pressing until it locks
into place.
• Install hub cap to the wheel until "Click". Install self-tapping screw, until the screw is snug.
• Repeat process on the other side of the generator to install the second wheel.
Installing Support Leg (See fig 3)
• Parts needed - Support leg & M8 screw (2).
Raise the front end of the generator high enough to gain access to the bottom of the frame. Securely position props
•
underneath to support.
• Line up holes on the support leg bracket to the holes on the front of the generator frame.
• Attach the support leg using M8 screws (2).
Fig 3
ASSEMBLY
Fig 1
Fig 4
10
Fig 2