Brother FAX560 Service Manual page 95

Selector
No.
1 Frame length selection
2 Use of non-standard commands
3
No. of retries
4
5 T5 timer
6 T1 timer
7 Elapsed time for time-out control
for no response from the called
station in automatic sending
8
mode
NOTE: Selectors 1 through 5 are not applicable in those models which do not support ECM.
Selector 1: Frame length selection
Usually a single frame consists of 256 octets (1 octet = 8 bits). For communications lines with
higher bit error rate, however, set selector 1 to "1" so that the facsimile equipment can divide a
message into 64-octet frames.
Remarks: The error correction mode (ECM) is a facsimile transmission manner in which the
equipment divides a message into frames for transmission so that if any data error
occurs on the transmission line, the equipment retransmits only those frames
containing the error data.
Selector 2: Use of non-standard commands
If this selector is set to "0," the equipment may use non-standard commands (the machine's native-
mode commands, e.g., NSF, NSC, and NSS) for communications. If it is set to "1," the equipment
will use standard commands only.
Selectors 3 and 4: No. of retries
These selectors set the number of retries in each specified modem transmission speed.
Selector 5: T5 timer
This selector sets the time length for the T5 timer.
Selector 6: T1 timer
This selector sets the time length for the T1 timer.
Selectors 7 and 8: Elapsed time for time-out control
If the equipment receives no response (no G3 command) from the called terminal in automatic
sending during the time set by these selectors, it disconnects the line.
WSW09
(Protocol definition 1)
Function
V - 23
Setting and Specifications
0: 256 octets
0: Allowed
No. 3 4
0 0 : 4 times
0 1 : 3 times
1 0 : 2 times
1 1 : 1 time
0: 300 sec.
0: 35 sec.
No. 7 8
0 0 : 55 sec.
(U.S.A./Canada versions)
60 sec.
0 1 : 140 sec.
1 0 : 90 sec.
1 1 : 35 sec.
1: 64 octets
1: Prohibited
1: 60 sec.
1: 40 sec.
(Other versions)