Brother FAX560 Service Manual page 43

(4) Remove the screw and disassemble the ADF parts as illustrated below.
(5) Remove the four screws from the panel rear cover. (See the illustration given on the next
page.)
(6) Unhook the panel rear cover from the three latches provided on the control cover sub ASSY,
then slide the panel rear cover to the front to prevent it from catching the document front and
rear sensor actuators.
(7) Remove the two screws (one screw on base models) from the control panel PCB and slide the
control panel PCB to the front. Slightly lift up the PCB, unlock the LCD flat cable connector,
and disconnect the flat cable.
(8) Pull out the microphone (not provided on base models).
(9) Disconnect the panel-main harness from the control panel PCB.
(10) Disconnect the FPC key from the control panel PCB.
(11) As shown below, pull the locks outwards and gently pull out the LCD flat cable to take out the
LCD.
IV - 18