Table of Contents
Advertisement
Step
7
(The ABS indicator light does not go off)
1) Turn the ignition switch OFF.
2) Remove the upper meter panel. Refer to "Upper Meter
Panel Removal and Installation" in Section 9D in related
manual.
3) Open the fuse box and inspect the signal fuse (1).
CAUTION
!
If a fuse is blown, find the cause of the problem
and correct it before replacing the fuse.
Signal fuse
15 A
Is the signal fuse OK?
8
1) Turn the ignition switch OFF.
2) Disconnect the ABS control unit coupler. Refer to "ABS
Control Unit Coupler Disconnect and Connect (AN400A/
ZAK9)" (Page 4E-71)
3) Turn the ignition switch ON with the ABS control unit
coupler disconnected, measure the voltage between
"16" (O/Y) and "24" (B/W) at the coupler.
Special tool
(A): 09900–25008 (Multi circuit tester set)
Tester knob indication
Voltage (
)
Normal value ("16" – "24")
Battery voltage (12.0 V and more)
ABS control unit coupler (Harness side)
18
10
3
2
Is the voltage between "16" and "24" normal?
Action
1
( )
21
24
25
16
12
13
8
9
4
(A)
( )
Yes
Go to Step 8.
I905H1450018-01
Go to Step 9.
(A)
I718H1450036-04
ABS:
4E-19
No
Replace the signal fuse.
Inspect the wire
harness. (Faulty ignition
or ground wire)
Hide quick links:
Advertisement
Table of Contents
