Suzuki AN400 Supplementary Service Manual page 57

ABS Component
Wheel speed sensor – sensor rotor clearance
inspection
Inspect the clearance between the wheel speed sensor
and sensor rotor for each wheel using the thickness
gauge.
Special tool
(A): 09900–20803 (Thickness gauge)
(B): 09900–20806 (Thickness gauge)
Wheel speed sensor – Sensor rotor clearance
Front: 0.36 – 1.62 mm (0.014 – 0.064 in)
Rear: 0.16 – 1.62 mm (0.006 – 0.064 in)
ABS control unit/HU ground wire inspection
1) Turn the ignition switch OFF.
2) Open the front box and remove the battery cover.
Refer to "Battery Removal and Installation" in
Section 1J in related manual.
Front
(A), (B)
I905H1240005-02
Rear
(A), (B)
I905H1240009-02
3) Disconnect the battery (–) lead wire (1).
4) Disconnect the ABS control unit coupler (2). Refer to
"ABS Control Unit Coupler Disconnect and Connect
(AN400A/ZAK9)" (Page 4E-71).
5) Check for continuity between "24" (B/W) at the
coupler and the battery (–) terminal, also "25" (B/W)
at the coupler and the battery (–) terminal.
Special tool
(A): 09900–25008 (Multi circuit tester set)
Tester knob indication
Continuity ( )
ABS control unit coupler (Harness side)
18 21
10 12 13
3
2 4
ABS: 4E-15
1
I905H1450013-01
2
I905H1450015-01
(A)
24 25
16
8 9
I718H1450030-03
(A)
I905H1450014-01