Table of Contents
Advertisement
4.
Select Configuration > Wireless Bridge.
Note:
If the access point is using the Auto channel setting, you are prompted
to select a channel. To specify the channel, select Configuration >
Wireless > Basic, select a channel, and click the Apply button.
5.
Select the band that you want to use for the bridge:
•
To set up the bridge on the 2.4 GHz band, click the 802.11b/bg/ng tab.
•
To set up the bridge on the 5 GHz band, click the 802.11a/na tab.
6.
Select the Enable Wireless Bridging check box.
7.
Select the Wireless Point-to-Point Bridge radio button.
8.
To enable wireless client association, select the Enable Wireless Client Association check
box.
9.
Click the Edit button.
10.
In the Remote MAC Address field, enter the MAC address of the other access point.
11.
Under Authentication Settings, specify the authentication settings for your bridge network.
12.
Click the Apply button at the bottom of the screen.
Your settings are saved.
13.
Configure and verify the following parameters for the access point:
•
Verify that both access points are configured to operate in the same LAN network
address range as the LAN devices.
Outdoor High Power Wireless N Access Point
Network Settings
38
Advertisement
Table of Contents
Troubleshooting
