NETGEAR WND930 Reference Manual page 21

5. Select the profile that you want to change and click the Edit button at the bottom of the
screen.
The fields that display depend on the security settings.
6. To change the wireless network name, in the WIreless Network Name (SSID) field, enter
the new wireless network name.
7. To broadcast the wireless network name, select the Broadcast Wireless Network Name
(SSID) Yes radio button.
8. In the Network Authentication list, select the authentication type:
• Open System. This selection can be used with WEP encryption or no encryption.
• WPA2-PSK. Select this option only if all clients support WPA2. If you select this
option, you must use AES and TKIP + AES encryption and enter the WPA
passphrase (network key).
• Mixed WPA/WPA2-PSK. This selection allows clients to use either WPA (with TKIP)
or WPA2 (with AES). If you select this option, you must use TKIP + AES encryption
and enter the WPA passphrase (network key).
9. In the Data Encryption list, select the data encryption type.
The options available for data encryption depend on the option you select in the Network
Authentication list. Select one of the following:
• None. No encryption is used.
• 64 bits WEP. This is standard WEP 40/64-bit encryption.
• 128 bits WEP. This is standard WP 104/128-bit encryption.
• 152 bits WEP. This is a proprietary mode, that works only with other wireless devices
that support this mode.
• AES. This is the standard encryption method for WPA2. Some clients support AES
with WPA, but this access point does not.
• TKIP + AES. This setting supports both WPA and WPA2. Broadcast packets use
TKIP. For unicast (point-to-point) transmissions, WPA clients use TKIP, and WPA2
clients use AES.
10. To prevent associated wireless clients from communicating with each other, select Enable in
the Wireless Client Security Separation list.
This feature is intended for hotspots and other public access situations.
Outdoor High Power Wireless N Access Point
Initial Setup
21