Table of Contents
Advertisement
A t t a c h i n g t h e S a f e t y S t r a p
1. Turn the printer upside down, resting its
top on the table.
2. Remove the stylus strap from the loop.
3. Take the thin end of the safety strap, and
push it through the loop at the bottom of
the printer handle (near the battery
compartment).
4. Push the thick end of the safety strap
through the thin end's loop.
5. Pull the strap. It may be necessary to
help the thin end's loop fit over the plastic
piece in the middle of the strap.
6. Pull the strap tight.
7. Attach the stylus strap to the loop as
shown.
1-4 Introduction
Advertisement
Table of Contents
