Filling The Tank; Maintenance Of The Boiler - Reliable Enviromate T630 Instruction Manual

FILLING THE TANK

If the (low) water level control light (4) comes on during usage, and you would like to
continue using the steam cleaner, you will need to follow the following steps:
1. Turn the main switch (1) to the 1
element).
2. Hold the steam control on the handle (10) until all the steam has evacuated the steam
cleaner.
3. When there is no more steam, turn the main switch to the off position.
4. It is now safe to open the water tank cap (6). Refill the steam cleaner with warm (for
faster heat up) water, refasten the water tank cap, turn main switch (1) to the 2
position and wait for the steam control light (3) to turn on.

MAINTENANCE OF THE BOILER

To maintain your steam cleaner in good condition and to ensure constant performance,
we recommend that you periodically clean the boiler once or twice a year depending on
the hardness of the water:
Cleaning Instructions
Attention: Before cleaning the boiler with the supplied de-scaling powder, please make
sure that the boiler is at room temperature, that it has not been used for at least 8 hours,
and that the boiler is disconnected from the power source.
1. Unscrew and remove the filling cap (6), turn the steam cleaner over and eliminate
all water remaining in the boiler.
2. Dissolve completely the contents of the single package of de-scaling powder in 2
cups (0.5l) of water.
3. Pour the solution into the boiler.
4. Leave the solution in the boiler for one night with the filling cap off.
5. Completely empty the contents of the boiler and rinse three or four times with
water in order to eliminate possible residues of scale.
6. It is a good idea to spray the first steam onto a cloth and not directly on any surface
since there still may be scale in the system.
Attention: It is not recommended that you use any other chemical to clean this product.
Doing so will automatically void the warranty.
ATTACHMENT COUPLINGS
If the attachment connections dry up after intensive use, put a small amount of lubricant
(Vaseline) around the O-rings on the male attachment.
st
position (this shuts off the power to the heating
nd