Whirlpool AKC921C/IX User Manual page 2

These instructions have been drawn up for your safety and that of others. You
are therefore requested to read them carefully before installing and using the
appliance. Keep this instruction manual for future reference as necessary. If the
appliance is sold or moved, make sure that the manual is handed over to the new
user .
Installation
·prior to installation, ensure that the local distribution conditions (nature of the gas
and gas pressure) and the adjustment of the appliance are compatible.
·this appliance is not connected to a combustion products evacuation device. It shall
be installed and connected in accordance with current installation regulations.
Particular attention shall be given to the relevant requirements regarding
ventilation
·Installation of the appliance and its connection to the electrical mains must only be
carried out by QUALIFIED PERSONEL. Before any procedure, it is important to
check that the appliance is DISCONNECTED from the electrical mails.
·It is risky to modify or attempt to modify the characteristics of this product.
·After removing the appliance from the packaging, make sure that it is undamaged
and that the electrical lead is in perfect condition. Otherwise, contact your dealer
before putting the appliance into operation.
·The Manufacturer declines all responsibility in case of failure to comply with the
accident prevention regulations.
·Make sure that air is able to circulate freely around the appliance. Poor ventilation
produced a shortage of oxygen.
· Make sure that the appliance is supplied with the type of gas indicated on the date
plate on the appliance.
· Use of a gas cooking appliance produces heat and moisture in the room in which it
is installed. Ensure that the room is well ventilated by keeping the air intakes open
and in good working order or by installing an extractor hood with discharge pipe.
· If the appliance is used intensively for a long time the effectiveness of the
ventilation will have to be increased, for example by opening a window or
increasing the power of any electric extractor fan.
2