Table of Contents
Advertisement
10
A
SSEMBLY
Tools Required: 4 mm hex wrench, 8mm x 10mm Open End Wrench,
Screwdriver
Parts Required: Power Head, Drive Shaft/Gear Case Assembly,
Front (Loop) Handle Assembly:
Loop Handle, Handle Mounting Bracket
5 x 35 mm screws (4), 5 mm hex nuts (4)
/
DRIVE SHAFT
GEAR CASE ASSEMBLY
1.
Loosen bolt (A) at engine drive shaft clamp.
2.
Remove vinyl cap from drive shaft.
3.
Carefully fit drive shaft assembly to engine, making sure that
inner drive shaft engages clutch mount.
NOTE
Lower gear housing cutter head assembly must be in line with the
engine.
4.
Turn drive shaft assembly so that center line of housing is midway
between the two arrows on drive shaft.
5.
Tighten bolt (A).
/
POWER HEAD
A
A
Advertisement
Table of Contents
