Packaging Instructions - HP 9130K Service Manual

Maintenance
5-17
3. Apply power to the system. The DSU and adapter cable require +5VDC while the
disc drive requires both +5VDC and + 12VDC. A dual power supply capable of
outputting +5VDC and + 12VDC at 2ADC minimum is recommended.
4. Upon applying power, the DSU self test is initiated. This is evident by the three 8's
seen on the DSU display. During the DSU self test, the drive motor will run. If the DSU
self test fails, the DSU display will read "bAd". Re-initiate the self test by depressing
the SYSTEM RESET pushbutton on the DSU. When the DSU has passed the self test,
the DSU display will read "000" and the drive motor will stop. At this time the TRK 0,
Drive Ready and RDIWR DATA LED's should be lit. If a write protected disc has been
inserted into the drive, the WRITE PROTECTED LED will be lit.
5. Depress the DRIVE VALIDATE pushbutton (the drive is selected when the DRIVE
VALIDATE pushbutton indicator is lit). The remaining DSU functions are now en-
abled by depressing the selected pushbuttons.
Packaging Instructions
The following instructions are provided to ensure proper packaging for safe shipment of the
9130K flexible disc drive assembly (less drive electronics board).
The following materials are required to package the drive assembly:
Description
I-Outer Box
I-Inner Box
I-Foam Pac
I-Foam Latch Insert
2-Foam End Caps
HP Part Number
9211-3595
9211-3594
4208-0368
9220-3448
9220-3450
To ensure damage free shipment of the 9130K drive assembly, follow these instructions:
1. Remove and retain the drive electronics board fastened to the top of the drive.
2. Open the front latch and insert the foam latch insert (PIN 9220-3448) as shown in
Figure 5-1:5.
Figure 5-15: Foam Latch Insert