9130K Flexible Disc Drive Exploded View - HP 9130K Service Manual

4-2
Assembly Access
Figure 4-1: 9130K Flexible Disc Drive Exploded View
To access the internal assemblies, the drive electronics board Al must first be removed. To
do this, refer to Figure 4-2 and disconnect connectors P5, P6 and P8 through P13. Next
remove the two screws (A) and slide the board toward the rear of the drive so that the
notches in the sides of the board are centered about the two side retainers. Lift the board
from the drive and place on a clean dry surface.
The servo electronics assembly (A2) is removed by disconnecting connectors P20 and P2I
and then removing the two screws (B). Be careful not to lose the two fiber spacers (C)
located behind the board when removing the retaining screws. Place the board on a clean
dry surface.