Checkpoint; Eas Controller Settings; Eas Controller; Eas Mode Of Operation - Honeywell Genesis 7580g User Manual

Checkpoint

EAS Controller Settings

The following switch settings for a Checkpoint Counterpoint IX controller can be used as a starting point, however, these
settings should be tuned according to your particular installation.

EAS Controller

Scan one of the following bar codes to turn EAS On or Off. Default = Off.
* Off

EAS Mode of Operation

Scan one of the following bar codes to select the EAS mode you wish to use.
When Interlocked is selected, EAS tag deactivation is interlocked with bar code scanning and transmission. When using Inter-
locked, you must set the timeout (see below).
When Continuous on Enable is selected, EAS tag deactivation is on all the time.
Default = Interlocked.
* Interlocked
7 - 2
SW2
On
1 2 3 4
SW1
On
1 2 3 4
5 6
5 6
On
Continuous on Enable