2. On the Set static IP menu, enter the static IP address. Use the dial pad and the
Add dot
soft key to enter characters. Press or to advance to the next
character.
3. Press and enter the Subnet Mask. Use the dial pad and the
enter characters. Press or to advance to the next character.
4. Press and enter the Gateway. Use the dial pad and the
enter characters. Press or to advance to the next character.
5. Press Save.
To set the VLAN ID for the deskset:
1. From the Network setting menu, press or to highlight VLAN ID, and then
press SELECT.
2. On the VLAN ID menu, press or to enable or disable the WAN Vlan.
3. Press and enter the WAN port number. Use the dial pad and the
key to enter characters. The valid range is 0 to 4095.
4. Press and then press or to enable or disable the PC port Vlan.
5. Press and enter the PC port number. Use the dial pad and the
to enter characters. The valid range is 0 to 4095.
6. Press Save.
To set other settings (DNS and NTP):
1. From the Network setting menu, press or to highlight Others, and then
press SELECT.
If DHCP is disabled, the Others menu appears. If DHCP is enabled, an error
message appears briefly before returning you to the Network setting menu.
2. Enter the IP address for the primary DNS server. Use the dial pad and the
Add dot
soft key to enter characters. Press or to advance to the next
character.
3. Press and enter the IP address for the secondary DNS server. The deskset uses
this server if the primary server does not respond.
VSP725 Administrator and Provisioning Manual
Add dot
15
Add dot
soft key to
soft key to
Backspc
soft
Backspc
soft key
Using the Phone Menu