Bosch DS484Q Installation Instructions Manual page 7

.
Back-to-Back Pole Mounting
Figure 8: Back-to-Back Pole Mounting
1. With spacers between the two units, mount the
transmitter and the receiver back-to-back. Refer to
Figure 8.
2. Use nuts and bolts to attach each unit firmly to the
pole.
Figure 9: Wall Mounting
1 - Chassis
2 - Base
3 - Cover
4 - Mounting holes
Bosch Security Systems, Inc. | 7/05 | 4998138530F
DS484Q/DS486Q | Installation Instructions | 2.0
1
5
4
6
7
3. Make sure that the units are aimed so that the
transmitter and the receiver in the same set are
aligned with each other.
2.2.2 Wall Mounting
Refer to Figure 9 for Steps 1 through 7.
1. Loosen the transmitter's cover mounting screw and
remove the cover.
2. Loosen the two base mounting screws and remove
the chassis by sliding it down against the base.
3. Insert wiring through the chassis wire entrance,
leaving enough wire to access the transmitter's
terminal block.
4. Insert the chassis mounting screws through the
mounting holes to mount the chassis on the
mounting surface.
5. Insert wiring through the wire entrance of the
transmitter. Remove the wire entrance at the
bottom of the transmitter.
6. Reattach the transmitter to the chassis.
7. Repeat this mounting procedure for the receiver.
Make sure it is mounted in a direct line-of-sight to
the transmitter.
2 3
8
5 - Terminal block
6 - Wire entrance
7 - Base mounting screws
8 - Cover mounting screw
Installation
7