Bosch DS484Q Installation Instructions Manual page 6

DS484Q/DS486Q | Installation Instructions | 2.0
2.2 Mounting
Mount the DS484Q and DS486Q in one of two ways:
•
Pole mounted
•
Wall mounted
2.2.1 Pole Mounting
1. Choose an appropriate mounting location for
the system. Install poles with a clear line-of-
sight between the transmitter and the receiver.
2. Loosen the transmitter's cover mounting screw
and remove the cover. Refer to Items 3 and 17
in Figure 1 on page 2.
3. Loosen the two mounting screws and remove
the chassis by sliding it down against the base
Refer to Refer to Items 1 and 9 in Figure 1 on
page 2.
Single Unit Pole Mounting
1. Use the short clamping screws to attach the
mounting plates to the chassis. Refer to Figure 6.
2. If the pole diameter is between 3.8 cm and 4 cm
(1.5 in. and 1.6 in.), use the shorter flange
(1.0 cm [0.4 in.]) of the mounting plate.
If the pole diameter is between 4 cm (1.6 in.) and
4.3 cm (1.7 in.), use the longer flange (1.5 cm
[0.6 in.]) of the mounting plate. This ensures that
the end of the screw does not contact the pole.
Figure 6: Using Mounting Plates
1
2
1 - Mounting plate
2 - Chassis
3 - Short clamping screws
3. Use the U-clamps and the long clamping screws to
attach the chassis firmly. Refer to Figure 7. Make
sure the transmitter is mounted in direct line-of-
sight of the receiver.
6
Installation
Figure 7:
1
1 - U-clamp
2 - Long clamping screws
4. Insert the wiring through the chassis wire entrance,
leaving enough wire to access the transmitter's
terminal block. Refer to Items 6 and 7 in Figure 1 on
page 2.
5. Slide the transmitter onto the chassis. Tighten the
base mounting screws. Refer to Figure 1 on page 2.
6. Repeat the mounting process for the receiver.
Make sure to mount the receiver in direct line-of-
sight of the transmitter.
3
Bosch Security Systems, Inc. | 7/05 | 4998138530F
Using U-clamps
2