Handlebar Switches - Yamaha FZS6V(C) Owner's Manual

INSTRUMENT AND CONTROL FUNCTIONS

Handlebar switches

Left
3
1. Dimmer switch " /
2. Turn signal switch " /
3. Horn switch " "
4. Hazard switch " "
Right
1. Engine stop switch "
2. Start switch " "
EAU12344
Dimmer switch "
Set this switch to "
beam and to "
Turn signal switch "
To signal a right-hand turn, push this
switch to "
turn, push this switch to "
leased, the switch returns to the center
position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
"
"
Horn switch "
Press this switch to sound the horn.
Engine stop switch "
Set this switch to "
the engine. Set this switch to "
stop the engine in case of an emergen-
cy, such as when the vehicle overturns
or when the throttle cable is stuck.
Start switch "
/ " Push this switch to crank the engine
with the starter.
EAU12400
/ "
" for the high
" for the low beam.
EAU12460
/ "
". To signal a left-hand
". When re-
EAU12500
"
EAU12660
/ "
" before starting
" to
EAU12710
"
3-6
CAUTION:
See page 5-1 for starting instruc-
tions prior to starting the engine.
Hazard switch " "
With the key in the "ON" position, turn
this switch to " " to turn on the hazard
lights (simultaneous flashing of all turn
signal lights).
The hazard lights are used in case of
an emergency or to warn other drivers
when your vehicle is stopped where it
might be a traffic hazard.
CAUTION:
Do not use the hazard lights for an
extended length of time with the en-
gine not running, otherwise the bat-
tery may discharge.
ECA10050
EAU12764
ECA10061